Coffee Dose Programming - LAVAZZA CLASSY PRO Instrucciones De Empleo

COFFEE DOSE PROGRAMMING

Measures are always programmed using the same
key, any other keys are ignored.
The programmed amount of milk, foam and cof-
fee supplied (min. 0,6 oz / 20 ml) can be modi-
fied by repeating programming.
Should a coffee dose lower than 0,6 oz (20 ml) be
set, the coffee machine will store in any case the
minimum coffee dose that can be set.
Lift the capsule loading lever until it locks into
position to open the capsule fitting compart-
ment.
Put a Lavazza Blue or Expert capsule into the
pod fitting compartment.
Lower the capsule loading lever to close the
pod fitting compartment.
If the programmed measure exceeds the max-
imum allowed (8oz/240 ml) the machine will
automatically stop delivery, the delivery button
will blink and the last programmed measure will
be saved in the memory.
If there is a power failure during programming, the
last programmed value remains in the memory.
If during a dose programming, water lack is indi-
cated, the machine stops the supply and the dose
being programmed won't be saved. Once filled
the water tank, repeat the dose programming
procedure.
PROGRAMMING
Press and hold one of the coffee delivery
for at least 5 seconds. The selected button will
flash and the coffee machine will enter the pro-
gramming mode. Now release the key.
During programming, the display shows the ani-
mation of the selected beverage.
Once the desired coffee amount is reached,
stop the brewing by pressing the button again.
For a new supply cycle, wait for supply buttons
and multifunction button turning on with
steady white light.
Once supply is over, lift and then lower the
capsule loading lever to unload the exhausted
capsule.
EN
17