Coffee Dose Programming - LAVAZZA SMEG Instrucciones De Uso

COFFEE DOSE PROGRAMMING

Place a cup or coffee cup under the dispenser.
Lift the loading lever until it locks, then fit a pod into
the compartment.
Press and hold one of the two coffee delivery buttons.
The selected button will flash and the coffee ma-
chine will enter the programming mode.
Once the desired amount of coffee has been ob-
tained, stop supply by releasing the button.
Lower the capsule loading lever to close the capsule
fitting compartment.
PROGRAMMING THE MACCHINE
29
The machine is set to the energy-saving mode is the
supply is not started immediately when a button is
kept pressed down. If the button is pressed down until
the operating temperature is reached, the supply will
start and, therefore, the desired dose can be pro-
grammed by releasing the button when the amount is
reached.
The programmed coffee supply quantity can be
changed as follows:
Min. 0.5 oz (15 cc)
Max. 8.4 oz (250 cc)
If the dose programming is lower than the permitted
minimum amount of 15 cc, the supply will continue,
when the button is released, until the previously set
dose is reached.
If the dose programming is higher than the permitted
maximum amount of 250 cc, the supply will stop and
the programmed dose will be set to the maximum value.
If the electric power supply fails during a dose pro-
gramming operation, the programming procedure will
have to be repeated.
If, during a dose programming operation, the machine
informs that water is not found in the tank, the dose
programming procedure will have to be repeated after
water is added.
EN