Energy Saving; Coffee Dose Programming - LAVAZZA CLASSY PLUS Instrucciones De Empleo

ENERGY SAVING

The machine will switch to the power-saving
mode after about 4 hours of being idle, and the
on/stand-by light will go out.
The machine can be manually switched to the
stand-mode by before the 4 hours' default time,
by means the ON/stand-by
ACOUSTIC SIGNAL
ACTIVATION / DEACTIVATION
Set the machine to the stand-by mode.
Simultaneously keep ESPRESSO
MACCHIATO buttons depressed over at
least 2 seconds.
• The machine will emit one brief acoustic
signal to notify the deactivation.
• The machine will emit two brief acoustic
signals to notify the activation.
Once the procedure has been completed, the
machine will go back to the stand-by mode.
MACHINE SETTING
button.
and

COFFEE DOSE PROGRAMMING

The double shot and coffee doses cannot be
programmed with the milk-based beverages.
Press the On/Stand-by
machine on. The machine will be ready when the
On/Stand-by button stops blinking and the
supply button lights are ON steadily.
Lift the pod loading lever until it locks into posi-
tion to open the pod fitting compartment.
Put a Lavazza Blue or Expert capsule into the
capsule fitting compartment.
Lower the pod loading lever to close the pod fit-
ting compartment. Place the cup onto the plate.
Press down over 3 seconds the button of the
icon you wish to program. The selected icon will
flash quickly whereas the others buttons will turn
off, except for the on-off button, to indicate that
the programming mode has been accessed.
Keep the supply button depressed.
Once the desired amount of coffee has been ob-
tained, stop the supply by releasing the button.
The machine will stop and the dose will be pro-
grammed.
Measures are always programmed using the same
button; any action by pressing other buttons will be
ignored.
The programmed amount of brewed coffee can be
changed by repeating the programming.
If the programmed measure exceeds the maximum
one allowed, the machine will automatically stop
delivery, the delivery button will blink and the last
programmed measure will be saved in the memory.
If case of power failure during the programming
phase, the last programmed value will remain stored
in the memory.
If, during the dose programming, a missing water
condition is reported, the machine will stop supplying
and the dose being programmed will not be saved.
Once the water tank has been filled, the dose pro-
gramming procedure shall be repeated.
EN
button to switch the
13