Warranty - Brill 230RL Manual Del Usuario

Always use the equipment solely
for the purpose described in the
operating instructions.
Only use this unit in daylight or
when the area where you are
working is lit by ample artificial
lighting.
Wear eye protection and gloves.
Make sure that the air vents are
free of dirt.
Take care not to injury yourself
on the devices used to cut the
line.
Ensure that you are standing
safely and on firm ground, even
on a slope.
Work across the slope, never up
and down.
Do not work on excessively
steep slopes.
Be careful if you change direc-
tion on a slope, turn the machine
round or draw it towards you.
Be careful if you are going
backwards, risk of stumbling!
Work at an angle to the slope,
never upwards and downwards.
Do not work on excessively
steep slopes.

Warranty

The manufacturer warrants its
products for exclusively non-
commercial use for a period of
24 months from the date of
original purchase. This warranty
does not affect statutory war-
ranty claims. The warranty covers
all substantial faults of the prod-
uct, which are caused by defects
in material and workmanship.
If a product exhibits such
a defect we will, at our option,
Only push the equipment at
walking pace.
Turn the motor off if the equip-
ment has to be tilted when
transporting it over surfaces
other than grass and if you are
transporting the equipment
backwards and forwards to the
work area.
Never use the machine with
damaged protective devices or
without protective devices.
When starting or operating the
starter switch take care as stipu-
lated by the manufacturer's
instructions. Ensure that your feet
are far enough away from the
cutting tool.
Keep your fingers and feet away
from the cutting tool!
Never lift or carry a machine
with the motor running.
Each time you have to work on
the machine or leave it or top it
up, always switch off the motor.
A
Taking a Break
Never leave the equipment
unattended. If you stop work,
unplug the equipment from
the mains and store the equip-
ment in a safe place.
repair or replace it without cost
for parts and labour provided
the following requirements are
fulfilled:
The product must have
.
been sold to the customer in
a legally correct way.
The original receipt with the
.
customer's address, date of
purchase, model and product
designation is presented as
If you stop work to go to a dif-
ferent work area, it is essential
to turn the equipment off and
unplug from the mains.
Beware of Environmental
A
Influences
Never use the equipment
in the rain or in damp, wet
conditions.
Never work immediately
adjacent to a swimming pool
or garden pond with electrical
equipment.
Comply with local quiet periods
in your community!
A
Electrical safety
Check the power cable
regularly for damage and
signs of wear.
If you operate peripheral equip-
ment, first unplug the charger
from the power pack.
As a user of the appliance, you
are responsible for Third parties
in your range of action.
proof of purchase. The product
must have been purchased
within the EC.
The product was handled
.
properly and according to the
recommendations in the oper-
ating instructions. It is essential
that the product has been
maintained and cleaned
according to the information
in the operating instructions.
No attempt to disassemble or
GB
19