Troubleshooting - Brill 230RL Manual Del Usuario

shaft. Join the aerator cylinder
to the drive shaft by tightening
the screw as far as possible.
Assembly the left aerator cylin-
GB
der in the same way.

10. Troubleshooting

General
Faults usually occur if the unit
has not been handled, cared for
or maintained properly. The fol-
lowing table contains the most
common faults and remedies to
eliminate these faults. If you
have any other problems, please
contact your nearest service
centre authorised by the manu-
facturer, or your nearest
authorised specialist dealer.
Fault
Appliance is switched on.
Aerator cylinder does not rotate.
Aerator cylinder not working.
11. Instructions for correct use, safety instructions
Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and / or if the cutting device is
damaged or worn. Never dis-
able safety devices.
Check the work area before
starting work. Remove any
18
Please do not use any force
when assembling the aerator
cylinder. Ensure that the aerator
cylinder "R" is assembled right
and the aerator cylinder "L" is
assembled left.
Caution! Repairs that
A
require specialist knowl-
edge must only be carried out
by an authorised specialist.
Caution! For safety reasons,
A
only use original spare
parts supplied by the manufac-
turer or parts that have been
authorised by the manufacturer.
We expressly point out that in
accordance with product liability
Possible Cause
Aerator cylinder blocked by
grass and soil.
Mains cable defect.
Aerator cylinder incorrectly
assembled.
Aerator springs worn.
Lawn too high.
foreign bodies present (e. g.
stones, branches or bones).
Check for foreign bodies whilst
working.
Always wear sturdy shoes and
long trousers when working.
Never work barefoot or when
wearing only light sandals.
Only have cutting tools replaced
by Brill Service or your authorised
specialist dealer.
Ensure that all of the screws are
firmly tightened, the appliance is
then in a secure operational con-
dition.
laws, we are not liable for any
damage caused by our units if
this damage is due to improper
repair or if parts exchanged
are not our original parts or
parts approved by us, and if
the repairs were not carried out
at service centre authorised by
the manufacturer or by an
authorised specialist. The same
applies to spare parts and
accessories.
Remedy
Remove grass or soil.
Check the mains cable.
Remove the aerator cylinder
and re-assemble it (see 9).
You can obtain replacement
aerator cylinders from your Brill
dealer or from Brill Service.
Mow lawn.
Use /
A
Responsibility
Make sure that there are no
other people (especially children)
or animals within or near the
working area.
Powered equipment can cause
serious injuries! You are respon-
sible for safety in the area where
you are working. Never start
the equipment whilst tilted –
risk of injury!