Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always replace
both carbon brushes at a time.
Unscrew carbon brush covers (2) (fig. L).
Remove used carbon brushes.
Remove any carbon dust with compressed air.
Insert new carbon brushes. Brushes should easily move into brush-holders.
Fix carbon brush covers (2).
After the carbon brushes are replaced start the nibbler with no load and wait until the brushes fit
to the motor commutator. Entrust replacement of carbon brushes only to a qualified person. Only
original parts should be used.
All defects should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Parameter
Supply voltage
Input current frequency
Rated power
Cutter strokes (without load)
Steel cutting capacity
Aluminium cutting capacity
Width of nibbling groove
Minimum diameter of initial hole
Minimum circle cutting radius
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp
= 77,3 dB(A) K = 3 dB(A)
A
Sound power: Lw
= 88,3 dB(A) K = 3 dB(A)
A
Vibration acceleration: a
h
Do not dispose of electrically powered products with household wastes, they should be utilized in proper plants. Obtain
information on waste utilization from your seller or local authorities. Used up electric and electronic equipment contains
substances active in natural environment. Unrecycled equipment constitutes a potential risk for environment and human
health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa Topex)
informs, that all copyrights to this instruction (hereinafter Instruction), including, but not limited to, text, photographies, schemes, drawings and
layout of the instruction, belong to Grupa Topex exclusively and are protected by laws accordingly to Copyright and Related Rights Act of 4 February
2004 (ustawa o prawie autorskim i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments). Copying, processing, publishing,
modifications for commercial purposes of the entire Instruction or its parts without written permission of Grupa Topex are strictly forbidden and may
cause civil and legal liability.
TECHNICAL PARAMETERS
Sheet Metal Shears
2
(400 N/mm
)
2
(600 N/mm
)
2
(800 N/mm
)
(200 N/mm
2
)
2
2
= 6,4 m/s
K= 1,5 m/s
ENVIRONMENT PROTECTION
Value
230 V AC
50 Hz
500 W
2000 spm
1.6mm
1.2mm
0.8mm
2.5mm
5 mm
22mm
60mm
II
2 kg
2018
16
Publicidad
Tabla de contenido
