Abicor Binzel AUT 61GD Instructivo De Servicio página 35

MAG welding torches
11 Dismounting
12 Disposal
12.1 Materials
Dismounting may only be carried out by specialized personnel. Please make
sure that the shutdown procedures are strictly observed, before the dismounting
work begins. Ensure this also for the components integrated into the welding
system.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply.
• Cut off the gas supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTE
• Observe the information given in section 8 Removal from service on
page EN-14.
1 Disconnect the MAG welding torches from the power supply.
2 Remove worn parts.
For disposal, the local regulations, laws, provisions, standards and guidelines
must be observed. For the MAG welding torches to be properly disposed of,
they first must be dismounted.
 See 11 Dismounting on page EN-17
This product is mainly made of metallic materials which can be molten in steel
and iron works and are thus almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
11 Dismounting
EN - 17