Mounting The Wire Guide Liner - Abicor Binzel AUT 61GD Instructivo De Servicio

MAG welding torches

6.2 Mounting the wire guide liner

1
11
10
Gas diffuser
1
Torch neck
2
Wire conduit
3
Central connector
4
Liner
Fig. 2
NOTE
• New still unused liners have to be shortened to the actual length of the
cable assembly.
2
9
Retaining nipple
5
Retaining sleeve
6
Liner
7
Cable assembly
8
1 Lay down the cable assembly (8) straight.
2 Remove gas nozzle (10), contact tip (9), tip adaptor (11) and
gas diffuser (1) from torch neck (2).
3 Unscrew retaining sleeve (6) from central connector (4).
4 Slide liner (7) through the wire conduit (3) up to the retaining nipple (5).
5 Screw in retaining sleeve (6) by hand.
6 Cut off the excess length of the liner (7) flush with the torch neck (2) and
pull out the liner (7).
7 Sharpen the spiral guide liner beginning to an angle of approx. 40° and
debur the cutting point.
8 Slide sharpened liner (7) through the wire conduit (3) up to the retaining
nipple (5).
9 Screw in retaining sleeve (6) and tighten it.
10Screw in gas diffuser (1), tip adaptor (11) and contact tip (9) and attach
gas nozzle (10).
3
8
9
10 Gas nozzle
11 Tip adaptor
6 Putting into operation
4
5
7 6
Contact tip
EN - 9