VWR RV 8 Indicationes De Seguridad página 16

Fit & unfit the evaporation flask / push off mechanism
Mount the evaporation flask:
- Place the evaporation flask (R) on the Vapor tube.
- Turn the plastic nut (P) with the clip (S) counterclockwise until the clip can be put on the flange.
- Now turn the plastic nut clockwise until the clamp is hard up against the flange. When doing so, hold the
locking device (O) on the steam pipe.
Remove the evaporation flask:
- Hold the locking device (O) and loosen the plastic nut by turning it counterclockwise. This releases a tightly
clamped evaporating flask.
- Hold the evaporating flask at the flange and open the jaws of the clamp.
- Remove the evaporating flask.
- Check that the locking of vapor tube is still closed!
16