Switching On/Off - Boneco U7142 Manual Del Usuario

Operation U7142
J K L I M
en
G
A
F
20
A) Switching on/off
You can switch the unit on or off by pressing button A.
B) Hygrostat (pre-set moisture level)
By pressing multi-functional button B (vertical) you can
set the desired moisture level in %. A relative moisture
of between 40 and 60% is recommended. The accuracy
of measurement is +/- 5%. The unit will switch off when
H
the moisture level exceeds the desired setting. The unit will
not switch off if the indicator is set at the arrow sign. In that
B
case the continuous operation function is activated. Du-
ring selection the target value is displayed. The display will
C
automatically show the current value after a few seconds.
D
C) Timer
Using multi-functional button C (horizontal), the operation
E
time can be set - adjustable between 1 and 8 hours, or
continuous operation. Letter G shows the operating period
that has been set (1h/2h/3h/4h/5h/6h/7h/8h/continuous
operation). The display will automatically show the current
value after a few seconds.
D) Controlling mist output and Evaporator
output
By repeatedly pressing button D you can control the mist
output. The LO/ME/HI display (H) shows which of the three
levels (low/medium/high) you have selected.
E) Operation with pre-heating
Button E is used for switching the pre-heating on and off
(letter I lights up). As a result, the water is pre-heated to a
temperature of 80° C before entering the nebuliser space.
The mist now leaves the nebuliser space at a pleasant
temperature of 40° C. The advantage of this is that the
room temperature does not drop and, in addition, it signi-
ficantly improves the water quality maintenance (bacteria
are killed).
F) Auto/Sleep
The automatic and sleep modes can be activated by pres-
sing button F. By pressing the button once, the automatic
function is switched on (letter J appears on the display),
maintaining the optimum humidity subject to the tempera-
ture. Control takes place by means of output quantity and
pre-set target value. If the sleep function is switched on
(the letter K appears on the display), the target humidity is
60%; the operation time is automatically set at 6 hours; the
heating is switched on. In addition, the output quantity is
also controlled subject to the difference between the target
value and the actual value. If the sleep mode has been
activated, the alarm will be switched off.
L) Empty indicator
The transparent water tank makes it possible to see the
water level well. Furthermore, the unit shows on the display
(L) when water should be added.
M) Cleaning indicator
If symbol M and «CLEAN» appear on the display, the ap-
pliance should be cleaned as recommended by the ma-
nufacturer. This symbol comes on automatically every 2
weeks, depending on the level of use. The display can be
cancelled by depressing button A for between 10 and 15
seconds.