Toshiba RAV-SM562XT-E Manual Del Propietário página 11

Setting the clock
Before you start operating the air conditioner, set the clock of the
remote controller using the procedures given in this section. The clock
panel on the remote controller will indicate the time regardless of
whether the air conditioner is in use or not.
Initial setting
When batteries are inserted in the remote controller, the clock panel
will indicate AM 0:00 and will flash.
(1) TIMER button
Push the TIMER
Each push of the TIMER button changes the time in one minute steps.
Pushing the TIMER button continually changes the time in ten
minute steps.
(2) SET button
SET
Push the SET button.
SET
The current time is indicated and the clock starts.
Clock adjusting
(1) CLOCK button
Push the CLOCK button.
The CLOCK display flashes.
(2) TIMER button
Push the TIMER
the current time.
Each push of the TIMER button
changes the time by one minute.
Pushing the TIMER button
continually changes the time by
ten minutes.
(3) SET button
SET
Push the SET button.
SET
The current time is indicated and
the clock starts.
Preparing the filters
(1) Open the Air inlet grille with both
hands until the stop position.
(2) Remove the Air filters from the
Front panel.
(3) Install the Sasa-Zeolite plus filter
and Bio-enzyme & Gingko filter in
the Filter frame and then install it
to the Air filters.
(4) Insert the Air filters in the Front
panel and hook them into position.
(5) Close the Air inlet grille.
button to set the current time.
SWING
button to set
FAN MODE AUTO
ECO Hi-POWER
TIMER
FIX MEMO
ON OFF SET CLR
FILTER
RESET CLOCK CHECK
Push CLOCK
(2)
(3)
6
FAN
SWING
FIX
ON
(1)
(2)
PRESET
START/STOP
FAN MODE AUTO
SWING ECO Hi-POWER
TIMER
MEMO
FIX
ON OFF SET CLR
FILTER
RESET CLOCK CHECK
Filter frame
Sasa-Zeolite
plus filter
Air filter
PRESET
START/STOP
MODE AUTO
ECO Hi-POWER
TIMER
MEMO
OFF SET CLR
FILTER
RESET CLOCK CHECK
(1)
Filter frame
Bio-enzyme &
Gingko filter
Air filter