Maintenance - Toshiba RAV-SM562XT-E Manual Del Propietário

MAINTENANCE

WARNING
Before you clean the air conditioner, be sure to turn off the circuit breaker,
or main power switch.
Cleaning of indoor unit and remote controller
CAUTION
• Use a dry cloth to wipe the indoor unit and remote controller.
• A cloth dampened with cold water may be used on the indoor unit if it is
very dirty.
• Never use a damp cloth on the remote controller.
• Do not use a chemically-treated duster for wiping or leave such
materials on the unit for long. It may damage or fade the surface of the
unit.
• Do not use benzine, thinner, polishing powder, or similar solvents for
cleaning.
These may cause the plastic surface to crack or deform.
• Do not wash the unit with water. It may cause an electric shock.
• Do not use alcohol, benzene, thinner, glass cleaner, polishing powder,
etc. for cleaning the unit, because they deteriorate in electric insulation.
If you will not use the unit for at least 1 month
(1) Operate the air conditioner in FAN ONLY mode for about half a day to
dry the inside of the unit.
(2) Stop the air conditioner and turn off the circuit breaker.
(3) Remove the batteries from the remote controller.
Check before operation
CAUTION
• Check that the Air filters are installed.
• Check that the Air outlet or inlet of the outdoor unit is not blocked.
Cleaning the Air filter
Clean the Air filters every 2 weeks.
If the Air filters are covered with dust, the performance of the air conditioner
will deteriorate.
Clean the Air filters as often as possible.
(1) Open the Air inlet grille with both hands until the stop position.
(2) Remove the Air filters from Front panel.
(3) Remove the Sasa-Zeolite plus filter and Bio-enzyme &
Gingko filter from the Air filters.
(4) Use a vacuum cleaner to remove the dust from the
filters or wash them with water.
If you wash the Air filters, dry them in the shade.
(5) Install the Sasa-Zeolite plus filter and Bio-enzyme &
Gingko filter in Filter frame.
(6) Insert the Air filters into the front panel guide, and hook
it into position.
(7) Close the Air inlet grille.
If the FILTER lamp on the indoor unit is indicated,
push the FILTER button on the remote controller, or
the TEMPORARY button on the indoor unit to turn
off the lamp.
17
Wipe with dry cloth
With the
MODE button
set to
FAN ONLY.
FAN ONLY operation
Filter frame
Filter frame
Bio-enzyme
Sasa-
& Gingko
Zeolite plus
filter
filter
Air filter Air filter