Hydrocarbon (Hc) Warning; For Products With A Water Dispenser/Ice Machine - Beko RCNE560E40ZXBN Manual Del Usuario

Safety and environment instructions
problems may arise if any object is
placed onto the product.
If the product has a door handle, do
•
not pull the handle when re-locating
the product. The handle might be
loose.
Be careful not to jam your hand or
•
any other body part in the moving
parts of the refrigerator.
Do not put your hand or any other
•
foreign materials into the ice
machine while it is operating.

1.1.1 Hydrocarbon (HC) Warning

If your product's cooling system
•
contains R600a:
This gas is flammable. Therefore, pay
attention not to damage the cooling
system or the piping during use and
transportation. If damaged, keep
the product away from potential fire
sources that may cause it to catch
fire and ventilate the room where the
product is placed.
If the product is damaged and
if you see gas leak, please
keep away from the gas. It may
C
cause frostbite when it gets into
contact with the skin.
(including R134)
Ignore this warning if the cooling
C
system of your product contains
R134a.
Type of gas used in the product
is stated on the type plate which
C
is on the left wall inside the
refrigerator.
Refrigerator / User Guide
WARNING:
A
Never throw the product into fire
for disposal.
1.1.2 For Products with a Water
Dispenser/Ice Machine
Pressure for cold water inlet shall
•
be maximum 90 psi (620 kPa). If
your water pressure exceeds 80 psi
(550 kPa), use a pressure limiting
valve in your mains system. If you
do not know how to check your
water pressure, ask for the help of a
professional plumber.
If there is a risk of water impact
•
in your installation, always use a
water impact protection equipment
in that installation. Please consult
professional plumbers if you are not
sure if there is water impact in your
installation.
Do not make installation on the hot
•
water inlet.
Use drinking water only.
•
Take the necessary measures
•
against the freezing risk of the
hoses. The water temperature
operating range must be 0.6°C
(33°F) minimum and 38°C (100°F)
maximum.
WARNING:
Never connect the product
A
to a cold water mains with a
pressure of 550 kPa (80 psi)
or above.
11/35EN