Initial Operation; Mounting The Lower Bar; Mounting The Handlebar; Fitting The Starter Cable - Deltafox DG-PLM 5125 SP Traducción Del Manual De Instrucciones Original

• Do not attempt to repair the equip-
ment yourself unless you are trained
to do so. Any work not specified in
these instructions is to be carried out
only by customer service centres au-
thorised by us.
• Keep the equipment in a dry place
and out of reach of children. Machines
are dangerous if used by inexperi-
enced people.

Initial operation

Caution! Risk of injury from rota-
ting blades. Carry out work on the
equipment only when the blade is
switched off and stationary.
Before starting the equipment, you must
- Remove the Protective Caps
-

Mounting the lower bar

- Install the handle bar
- Install the grass collection box
- Install the starter cord
- Fill with engine oil
- Fill with petrol
- adjust cutting height if required
Mounting the lower bar
1. Fold the lower bar (3) outwards,
together with the handlebar (1).
2. Fasten the lower bar (3) to
the lawnmower with the star
grip screws (7) and carriage
bolts (7a). You can determine
the desired tilt for the bar by se-
lecting one of the two possible
screw positions.

Mounting the handlebar

Make sure that the Bowden ca-
bles (6) are not squeezed when
the grip is installed.
1. Place the handlebar (1) onto the
lower bar (3).
2. Push the thread of the quick-re-
lease lever (4) through the drill
holes from the outside.
3. Screw a nut (4a) onto the thread
of each of the quick-release le-
vers (4).
4. Lock the quick release levers (4)
by pressing them towards the
handlebar (1).
The quick release levers (4) must rest
against the bar in such a way that tigh-
tening can be carried out with medium
force. Otherwise, the quick release levers
must be turned clockwise for tensioning
them or anti-clockwise to loosen them.
5. Fasten the Bowden cable (6)
using a cable clamp (5) to the
lower bar (3).

Fitting the starter cable

1. Pull the safety bracket (2) to-
wards the handlebar (1) and
hold it in this position.
2. Slowly pull the starter cable by
the starter handle (25) towards
the bar.
3. Guide the starter cable into the
starter cable guide (24).
4. Release the safety bracket (2).
GB
109