X-lander X-CITE Manual Del Usuario página 10

Pull the lever upwards and adjust the seat to the desired position.
I N C R E A S I N G T H E H O O D I N C L I N AT I O N A N G L E
17
The hood may be expanded by an additional part. In order to do this, undo the zipper
between the upper and lower part of the hood.
I N S TA L L I N G O F B U M P E R B A R
18
Push in the ends of the bumper bar into mounting holes, until locks are snapped.
TA K I N G T H E B U M P E R B A R O F F
19
Push in the buttons of the guard-rail locks and slide its end out of the mounting holes.
The bumper bar may be tilted, when undone only from single side.
AT TAC H I N G T H E C OV E R
20
To attach the footcover put it under the bumper bar and attach to Velcro (a) and snap (b).
21
P L AC I N G A N A D D I T I O N A L S E AT PA D
Unfasten the straps buckle (a). Place the seat pad on the stroller's seat and move the
seatbelts through the openings as shown in (b, c). Add the shoulder pads on the shoulder
belts as shown in (d,e)
22
B U C K L E
To unfasten the buckle, press the buttons and pull the fastening part out of the casing. To
fasten the buckle, insert the fastening part into the casing until it has engaged.
M O U N T I N G T H E C A R S E AT
23
Special adapters are needed in order to mount the baby car seat. Place the adapters
in mounting seats of the frame and attach the car seat by catching it on the adapters.
Attention: Ensure proper fitting of the armchair before using it.
24
R E M OV I N G T H E C A R S E AT
In order to take the car seat off, push in the unlocking pushbuttons on both its sides,
while simultaneously pulling it out of mounting seats. Remove adapters by pushing in the
unlocking pushbutton.
25
M O U N T I N G O F C A R R YC OT
Special adapters are needed in order to mount the carrycot. Place the adapters in mo-
unting carrycot of the frame and attach the carrycot by catching it on the adapters.
D I S M O U N T I N G O F C A R R YC OT
26
To take the carrycot off, push in the buttons unlocking the catches (a) and pull it out from
mounting seats (b). Remove adapters by pushing in the unlocking pushbutton.
M O S Q U I TO N E T
27
The mosquito net is in the pocket under the footrest (a). Place it over the footrest and
the hood (b) and then fasten the straps round the frame bars as shown in Figure (c).
28
L E D L I G H T S
The stroller frame features LED lights .The ON button is located on the stroller frame as
shown in the picture below. The batteries are located on the bottom of the footrest. In
order to install the batteries LR 44, unscrew the screw shown in the picture and take off
the casing.
AT TAC H I N G X- B AG N U R S E R Y B AG A N D X - M U G H O L D E R
29
X-Mug and X-Bag nursery bag can be attached to the frame using the holders shown in
the picture.
8