X-lander X-CITE Manual Del Usuario página 9

1 U N F O L D I N G T H E F R A M E
Unclip the linking interlock (a). Unfold the pram by lifting its handle up until the locks (b)
are engaged . WARNING:
gears have been locked.
F O L D I N G T H E F R A M E
2
Detach the pram, seat unit or car seat from the frame. Pull the grips on the handle
upwards (a). Fold the frame holding the handle until the automatic lock is engaged as
shown in the picture(b).
A S S E M B LY A N D D I S A S S E M B LY O F R E A R W H E E L S
3
To assembly or disassembly the wheel, push rubber button, which is in the middle of the
wheel.
M O U N T I N G O F T H E F R O N T W H E E L
4
In order to mount the wheel, slide it onto the axle until the lock is engaged.
D I S M O U N T I N G O F F R O N T W H E E L
5
In order to take the wheel off, push the button shown on the figure (a), and pull the wheel
off the axis (b)
W H E E L B LO C K A D E
6
The stroller is provided with swiveling front wheels. A special button blocks the wheel
swiveling movement. After the button has been pressed, the wheels are blocked to go
straight. To release the blockade, press the lever.
P U S H B A R
7
Press the button in the middle of the handle and adjust its height by pulling it towards
you to lengthen it or pushing it away from you to shorten it.
B R A K E
8
To apply the brake: push the pedal down with your foot (a). To release the brake push the
pedal down from the other side (b).
A D J U S T I N G O F H A R N E S S
9
Use the regulation underneath the shoulder pads.
R E G U L AT I O N O F T H E H E I G H T O F T H E S A F E T Y H A R N E S S
10
The height of the safety harness can be adjusted depending on the age of the child.
Position 1 - When the child starts to sit unaided (around 6 months)
Position 2 and 3 - When the shoulders of the child will be at the middle or high holes level
S H O P P I N G B A S K E T I N S TA L L AT I O N
11
Fasten the snap fasteners and attach the basket to the chassis as shown in the pictures.
I N S TA L L I N G S E AT U N I T O N T H E F R A M E
12
Slide the catches of the seat unit nto mounting seats in the frame, until locks are enga-
ged. The seat unit can be mounted facing front or rear.
D I S M O U N T I N G S E AT U N I T F R O M T H E F R A M E
13
Push the buttons unlocking catches of seat unit in (a), then pull it out from mounting seats (b).
A S S E M B LY A N D D I S M A N T L I N G O F T H E C A N O P Y
14
To assemble the canopy, insert its clamps into the assembly openings (a). To remove the ca-
nopy, press in the interlocks of clamps and bring out the canopy from assembly openings (b).
F O OT R E S T A D J U S T M E N T
15
Press the buttons on both sides of footrest and adjust it to the required position.
16
A D J U S T I N G T H E S T R O L L E R S E AT P O S I T I O N
Prior to assembling the baby carriage make sure that folding
7