Operation; Switching Off - Hilti WSR 36‑A Manual Del Usuario

7. Operation

NOTE
en
To ensure good cutting performance and minimize
stress on the power tool, use only saw blades that
are in good condition.
CAUTION
Do not overload the power tool. It will work more
efficiently and more safely within its intended per-
formance range.
CAUTION
Wear protective glasses and a dust mask. The
sawing operation swirls up dust and wood chips into
the air. The dust and wood chips may be harmful to
the eyes and respiratory system.
CAUTION
Dusts are hazardous to the health and can cause
respiratory or skin diseases and allergic reactions.
WARNING
Certain dusts are considered to be carcinogenic
(cause cancer). These include mineral dust as well as
oak and/or beech wood dust, particularly in conjunc-
tion with additional substances used for the treatment
of wood (chromate, wood preservatives).
CAUTION
Wear ear protectors. The power tool and the sawing
operation generate noise. Exposure to noise can cause
hearing loss.
CAUTION
Wear protective gloves. The cutting edges of the saw
blade teeth are sharp. The cutting edges may present
a risk of injury.
CAUTION
Always guide the power tool away from your body
when working with it.
CAUTION
Do not lift the power tool away from the workpiece
until it has stopped completely.
24
CAUTION
Lay the power tool down only when it has come to
a complete stop.
CAUTION
The saw blade gets hot during intensive use. Wear
protective gloves. Contact with the saw blade
presents a risk of burning injury.
7.1 Safe operation 10 11
DANGER
The power tool must be pressed against the work-
piece until the contact shoe makes firm contact.
This helps ensure maximum safety and good per-
formance.
DANGER
Always use saw blades that project at least 40 mm
beyond the workpiece over the entire length of the
blade stroke. This will help to avoid violent kickback.
7.2 Switching on
Press the transport lock and then press the control
switch.

7.3 Switching off

Release the control switch.
7.4 Adjusting the stroke rate 12
NOTE
The recommended stroke rate settings and inform-
ation about the correct choice of saw blade can be
found in the product information and in the corres-
ponding application table.
The recommended stroke rate can be preset by turn-
ing the stroke rate regulator.
See section: 2.4 Stroke rate setting
Press the control switch.
The power tool will then run at the preselected stroke
rate.
7.4.1 Selecting the stroke rate
1 = low stroke rate, 6 = high stroke rate