Charging The Battery - Hilti WSR 36‑A Manual Del Usuario

6. Grip and pull the contact shoe to check that it is
locked in position.
6.3 Pipe‐cutting adapter (accessory) 6 7
1. Pull the battery out of the power tool.
2. Removing the saw blade.
3. Press the contact shoe lockbutton and hold it in
this position.
4. Pull the contact shoe forward, away from the
power tool.
5. Push the pipe‐cutting adapter onto the front end
of the power tool and bring it into the desired
position.
6. Release the button.
7. Grip and pull the pipe‐cutting adapter to check
that it is locked in position.
8. Unscrew the clamp fully.
9. Place the chain around the pipe and hook it back
onto the pipe‐cutting adapter.
NOTE The clamping screw should lie at an angle
of 45° to the power tool.
10. Close the clamping screw.
6.4 Battery use and care
NOTE
Battery performance drops at low temperatures.
Never use the battery until the cells become fully
discharged. Change to the second battery as soon
as a drop in performance is noticed. Recharge the
battery immediately so that it is ready for reuse.
Store the battery in a cool, dry place. Never store
the battery where it is exposed to direct sunlight or
sources of heat, e.g. on heaters / radiators or behind a
motor vehicle windscreen. Batteries that have reached
the end of their life must be disposed of safely and
correctly to avoid environmental pollution.

6.5 Charging the battery

DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
6.5.1 Charging a new battery for the first time
A new battery must be charged correctly for the
first time before use. This will ensure that the cells
form correctly. Incorrect initial charging may have a
permanent, negative effect on battery capacity. Please
refer to the applicable battery charger's operating
instructions for information about initial charging.
6.5.2 Recharging a battery
Ensure that the outer surfaces of the battery are
clean and dry before inserting it in the corresponding
charger.
Read the operating instructions for the charger for
further information about the charging procedure.
Li‐ion batteries are ready for use at any time, even
when only partly charged. Charging progress is in-
dicated by the LED display (see charger operating
instructions).
6.6 Fitting the battery 8
DANGER
Use only the Hilti batteries and Hilti chargers listed
under "Accessories".
CAUTION
Check that the terminals on the battery and in the
power tool are free from foreign objects before
inserting the battery in the power tool.
1. Push the battery into the power tool from the rear
until it is heard to engage with a double click.
2. CAUTION A falling battery may present a risk of
injury to yourself or others.
Check that the battery is seated securely in the
power tool.
6.7 Removing the battery 9
1. Press both battery release buttons.
2. Pull the battery out of the power tool toward the
rear.
en
23