Initial Startup; Important; Power Supply; Charging The Battery For The First Time - Nedo CrossLiner 4 Manual De Instrucciones

5

Initial Startup

When starting the CrossLiner 4 up for the first time, charge the integrated set of rechargeable
batteries (3.6 V) using the charger supplied (see chapter 6.1).

Important!

Only use the charger supplied.
6

Power Supply

6.1

Charging the battery for the first time

Check whether the voltage given on
the charger's rating plate is identical
with the mains voltage.
The rechargeable batteries are fully
charged after 14 hours.
1 Insert the connector of the supplied
charger in the socket (1).
2 Connect charger to mains socket.
3 After fully charging the rechargeable
battery, disconnect the charger from the
mains socket.
6.2

Recharging the battery

If the visibility of the laser lines clearly dissipates despite use of the laser glasses, recharge the
battery using the charger supplied (see chapter 6.1).
Operating Instructions CrossLiner 4 16
EN
1
1