Initial Start-Up - Nedo ECO 600 HV Manual De Instrucciones

Structure
Control panel of the IR remote control
The button symbols and functions correspond to
the comparable buttons on the control panel of the
ECO 600 HV, see page 4.
Exception:
"Send" LED display
Briefly lights up when buttons 4, 5 or 12 are
13
Flashes as long as buttons 1, 2, 3 or 6 are
Initial Startup
ECO 600 HV
When starting the ECO 600 HV rotating laser up for the first time, charge the integrated set of
rechargeable batteries (4.8 V) using the charger supplied. The charger socket is located below
the handle, behind a rubber cap. The set of batteries is fully charged when the green LED on
the charger lights up.
Important!
Only use the charger supplied.
IR remote control
Insert the 2 batteries supplied (type AAA) in the IR remote control.
Ensure pole direction is correct!
Receiver
Insert the battery supplied (type 9V) in the receiver.
Ensure pole direction is correct!
Starting up the unit
When using on site, set up the ECO 600 HV according to the application.
Operating Instructions ECO 600 HV Rotating Laser
pressed.
pressed.
13
EN
13