Saivod ASG0918WI Manual Del Usuario página 99

Introduction for buttons on remote controller
● When selecting "
on indoor unit displays set temperature.
● When selecting "
displays indoor ambient temperature.
● When selecting "
displays outdoor ambient temperature.
Note:
● Outdoor temperature display is not available for some models. At that time, indoor
unit receives "
● It's defaulted to display set temperature when turning on the unit. There is no
display in the remote controller.
● Only for the models whose indoor unit has dual-8 display.
● When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically turn
to display set temperature after three or five seconds.
9
WiFi button
Press " WiFi " button to turn on or turn off WiFi function. When WiFi function is
turned on, the " WiFi " icon will be displayed on remote controller; Under status
of remote controller off, press "MODE" and " WiFi " buttons simultaneously for 1s,
WiFi modulewill restore to factory default setting.
● The WIFI function is only available for some models.
10
LIGHT button
Press this button to turn off display light on indoor unit. "
controller disappears. Press this button again to turn on display light. "
displayed.
11
CLOCK button
Press this button to set clock time. "
"▲" or " " button within 5s to set clock time. Each pressing of "▲" or "
clock time will increase or decrease 1 minute. If hold "▲" or "
time will change quickly. Release this button when reaching your required time.
Note:
● Clock time adopts 24-hour mode.
● The interval between two operation can't exceeds 5s. Otherwise, remote contro-
ller will quit setting status. Operation for TIMER ON/TIMER OFF is the same.
12
TIMER ON / TIMER OFF button
" or no display with remote controller, temperature indicator
" with remote controller, temperature indicator on indoor unit
" with remote controller, temperature indicator on indoor unit
" signal, while it displays indoor set temperature.
" icon on remote controller will blink. Press
98
" icon on remote
" icon is
" button,
" button, 2s later,
GB