Child Lock Function; I Feel Function - Saivod ASG0918WI Manual Del Usuario

Function introduction for combination buttons
● Sleep function and energy-saving function can't operate at the same time. If
energy-saving function has been set under cooling mode, press sleep button will
cancel energy-saving function. If sleep function has been set under cooling
mode, start up the energy-saving function will cancel sleep function.
8℃ heating function
Under heating mode, press "TEMP" and "CLOCK" buttons simultaneously to start
up or turn off 8℃ heating function. When this function is started up, "
will be shown on remote controller, and the air conditioner keep the heating status
at 8℃ . Press "TEMP" and "CLOCK" buttons simultaneously again to exit 8℃
heating function.
Note:
● Under 8℃ heating function, fan speed is defaulted at auto speed and it can't be
adjusted.
● Under 8℃ heating function, set temperature can't be adjusted. Press "TURBO"
button and the remote controller won't send signal.
● Sleep function and 8℃ heating function can't operate at the same time. If 8℃
heating function has been set under cooling mode, press sleep button will cancel
8℃ heating function. If sleep function has been set under cooling mode, start up
the 8℃ heating function will cancel sleep function.
● Under ℉ temperature display, the remote controller will display 46 ℉ heating.

Child lock function

Press "▲" and "
child lock function is on, "
the remote controller, the "
the unit.
Temperature display switchover function
Under OFF status, press "
erature display between ℃ and ℉ .

I FEEL Function

Press "▲" and "MODE" buttons simultaneously to start I FEEL function and "
will be displayed on the remote controller. After this function is set, the remote
controller will send the detected ambient temperature to the controller and the unit
will automatically adjust the indoor temperature according to the detected tempera-
ture. Press this two buttons simultaneously again to close I FEEL function and "
will disappear.
● Please put the remote controller near user when this function is set. Do not put
the remote controller near the object of high temperature o r low temperature in
order to avoid detecting inaccurate ambient temperature.When I FEEL function
is turned on, the remote controller should be put within the area where indoor
unit can receive the signal sent by the remote controller.
" simultaneously to turn on or turn off child lock function. When
" icon is displayed on remote controller. If you operate
" icon will blink three times without sending signal to
" and "MODE" buttons simultaneously to switch temp-
100
" and "8℃ "
GB
"
"