Cleaning And Maintenance - Ferm PDM1052 Traducción Del Manual Original

ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Exchanging and removing drill bits
Fig. A - B
The machine is suitable for use of the following
drill bits:
• Wood (HSS)
• Metal (HSS)
• Concrete / masonry (hard metal)
Before exchanging bits, first remove the
power plug from the wall socket.
Inspect bits regularly during use. Blunt
bits should be re-sharpened or replaced.
• Open the chuck (6) by turning the front
sleeve (11) clockwise while simultaneously
holding the rear sleeve (10) or turning it
counterclockwise and insert the bit into the
chuck opening.
• Tighten the bit by turning the front sleeve (11)
counterclockwise while simultaneously
holding the rear sleeve (10) or turning it
clockwise.
Mounting and removing the auxiliary grip (fig. C)
Mounting
• Loosen the auxiliary grip (8).
• Slide the auxiliary grip (8) over the chuck (6).
• Turn the auxiliary grip (8) to the required
position.
• Tighten the auxiliary grip (8).
Removing
• Loosen the auxiliary grip (8).
• Remove the auxiliary grip (8) from the chuck (6).
• Tighten the auxiliary grip (8).
Mounting and removing the depth stop (fig. D)
The depth stop is used to set the maximum
drilling depth.
6
USE
Switching on and off (fig. A)
• To switch on the machine, press the on/off
switch (1). The further the on/off switch (1) is
pressed, the higher the speed of the machine.
• To switch the machine to continuous mode,
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
• To switch off continuous mode, press the on/
off switch (1) again.
Forward/reverse switch (fig. A)
Do not change the direction of rotation
during use.
• For clockwise rotation, slide the forward/
reverse switch (4) to the left.
• For counterclockwise rotation, slide the
forward/reverse switch (4) to the right.
Setting the maximum drilling speed (fig. A)
Do not set the speed during use.
• Turn the speed adjustment wheel (3) clockwise
to increase the maximum drilling speed.
• Turn the speed adjustment wheel (3)
counterclockwise to decrease the maximum
drilling speed.
Setting the operating mode (fig. E)
Do not change the operating mode
during use.
• Set the switch (5) to position "A" for drilling.
• Set the switch (5) to position "B" for hammer
drilling.

CLEANING AND MAINTENANCE

Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
• Regularly clean the housing with a soft cloth.
• Keep the ventilation slots free from dust and
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.