Electrical Safety; Technical Specifications; Description (Fig. A) - Ferm PDM1052 Traducción Del Manual Original

• Make sure that the maximum speed for the
accessory is larger than or the same as the
maximum speed of the machine. Refer to the
rating plate on the machine.
• Before use, remove all nails and other metal
objects from the workpiece.
• Make sure that the workpiece is properly
supported or fixed.
• Keep your hands away from the workpiece
during use.
• Never put the machine down on a table or a
workbench before it has been switched off.

Electrical safety

Always check that the voltage of the
power supply corresponds to the voltage
on the rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
extension cable reel, always fully unroll the
cable.

Technical specifications

Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Protection class
Weight
Max. drill diameter
Wood
Concrete
Steel
Noise values
Sound pressure (L )
PA
Acoustic power (L )
WA
Uncertainty (K)
Vibration values
Impact drilling mode
Drilling into metal, a
Uncertainty (K)
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN 60745; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
- using the tool for different applications, or with
different or poorly maintainted accessories,
may significantly increase the exposure level
- the times when the tool is switched off or when
. If you use a it is running but not actually doing the job, may
2
significantly reduce the exposure level
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
230 V~
patterns.
50 Hz
800 W

DESCRIPTION (FIG. A)

0 - 3.000 /min
0 - 48.000 /min
Your impact drill has been designed for drilling
holes in wood, metal and plastics and for hammer
IP 20
drilling in brick and concrete.
2.2 kg
1. On/off switch
2. Lock-on button
3. Speed adjustment wheel
25 mm
4. Forward/reverse switch
13 mm
5. Switch for drilling / hammer drilling
10 mm
6. Chuck
7. Main grip
8. Auxiliary grip
91.7 dB(A)
9. Depth stop
102.7 dB(A)
10. Rear sleeve
11. Front sleeve
3 dB(A)
12. Power indicator light
h,D
Wear hearing protection.
15.238 m/s
2
4.98 m/s
2
1.5 m/s
2
5