Sanus VuePoint F35b Manual De Instrucciones página 8

2 Mount the Wall Plate
Wood stud
2-1 Locate studs
< 16 mm
(5/8 in.)
2-2 Mark the wall
2-3 Drill pilot holes
2-4 Tighten lag bolts
[01]
[06]
8
[01]
[05]
Verify the center of the stud using an awl, a thin nail, or an edge
to edge stud finder.
CAUTION:
Avoid potential personal injuries and
property damage!
 Any material covering the wall must not exceed 16 mm (5/8
in.).

Minimum wood stud size: common 51 x 102 mm (2 x 4 in.
{nominal 38 x 89 mm-1½ x 3½ in.}).
Level the wall plate [01] and mark the hole locations.
CAUTION:
Avoid potential injuries or property damage!
Pilot holes MUST be drilled to a depth of 75 mm (3 in.), using a 5.5
mm (7/32 in.) diameter drill bit.
75mm
3 in.
CAUTION:
Avoid potential injuries or property damage!
Improper use could reduce the holding power of the lag bolt.
To avoid potential injuries or property damage:

DO NOT over-tighten the lag bolts [06].

Tighten the lag bolts [06] only until the washers [05] are
pulled firmly against the wall plate [01].
13mm 5.5mm
)
(1/2 in.) (7/32 in.
6902-002030 <00>