Publicidad
IMPORTANT WARNING! It is critical that all Yakima racks and accessories be properly and securely attached to
your vehicle. Improper attachment could result in an automobile accident, and could cause serious bodily injury
or death to you or to others. You are responsible for securing the racks and accessories to your car, checking
the attachments prior to use, and periodically inspecting the products for adjustment, wear, and damage.
Therefore, you must read and understand all of the instructions and cautions supplied with your Yakima
product prior to installation or use. If you do not understand all of the instructions and cautions, or if you have
no mechanical experience and are not thoroughly familiar with the installation procedures, you should have
the product installed by a professional installer such as a qualified rack specialty installer or auto body shop.
1
REMOVE THE COVERS .
Use a flat head screwdriver to pry
up and remove the access doors
from the flush rails of your vehicle
3
REMOVE THE FLUSHRAIL.
5
PLACE THE SHORT SPACER.
Instruction #1036109A - Page 2 of 8
2
from each of the access doors of your vehicle.
6X
6X
Carefully lift the
flushrail from
your vehicle.
6
Place a short
spacer and
Use the 5 mm hex
apply silicone
wrench to install a
to the top of
flat washer and a
the spacer.
short bolt. Tighten
until the spacer is
slightly compressed
(.3 Nm of torque).
6X
6X
REMOVE THE FLUSHRAIL BOLTS .
Use a 12 mm wrench to remove the bolts
4
APPLY SILICONE.
Apply a generous amount of
silicone around the rear tubes
at each mounting point.
2X
2X
SECURE THE REAR SPACER.
.3 Nm
12X
12X
6X
6X
6X
6X
Publicidad
