Publicidad
7
INSTALL THE DITCH MOLDING.
Install the short ditch
molding between
the mounting point
toward the rear and
install the long ditch
molding between
the mounting points
toward the front.
APPLY SILICONE TO THE
8
CENTER MOUNTING POINTS.
Apply a generous amount of silicone around
the front tubes of the center mounting points.
9
PLACE THE MEDIUM SPACER.
Place a medium
spacer and
apply silicone
to the top of
the spacer.
APPLY SILICONE TO THE FRONT
11
AND REAR MOUNTING POINTS.
Apply a
generous
amount
of silicone
around the
front tubes
at the front
and rear
mounting
points.
Instruction #1036109A - Page 3 of 8
10
INSTALL THE CENTER LANDING PADS.
2X
2X
2X
2X
12
PLACE THE TALL SPACER.
Place a tall
spacer at the
front and rear
mounting
points and
apply silicone
to the top of
the spacer.
4X
4X
• For the center mounting points, use
the short pads and conical washer
with the base.
• Refer to the arrows inside the bases
and orient the bases so that the
arrows face outward from the vehicle.
• Use the 5 mm hex wrench to install the
pad, base, conical washer oriented as
pictured, and the bolt as shown.
• Fully tighten the long bolt.
4X
4X
4 Nm
2X
2X
4X
4X
Publicidad
