Publicidad
13
INSTALL THE FRONT AND REAR LANDING PADS.
• For the front and rear mounting
points, use the tall pads and conical
washer with the base.
• Refer to the arrows inside the bases
and orient them so that the arrows
face outward from the vehicle.
• Use the 5 mm hex wrench to install
the pad, base, conical washer oriented
as pictured, and the bolt as shown.
• Fully tighten the long bolt.
14
TEST THE INSTALLATION.
Jostle and rotate the
Landing Pad in all
directions to ensure it
is securely installed.
15
Continue with
SkyLine or
Control Tower
installation.
READ THESE WARNINGS!
• Make sure your SkyLine™ or Control Towers™
with bars installed seat completely with the
Landing Pads™. If they do not seat properly,
repeat steps 10 and 13.
• Be sure all hardware is secured according to the
instructions. Failure to perform safety checks
before driving away can result in property
damage, personal injury, or death.
• Attachment hardware can loosen over time.
Check and tighten if necessary, before each use.
Instruction #1036109A - Page 4 of 8
INSTALL THE COVERS WHEN
16
THE RACK IS NOT ATTACHED.
Using the covers will
help keep the bases
free of debris.
To review your vehicle's specific weight limit and load
limitations for accessories, visit yakimatech.com.
For additional product support, visit yakima.com/
support or contact us directly at (888)925-4621
Monday through Friday, 7:00 AM to 4:00 PM, PST.
DO NOT EXCEED THE
MAXIMUM WEIGHT LIMIT
FOR YOUR VEHICLE.
Remove your YAKIMA rack and accessories
before entering automatic car washes.
4 Nm
4X
4X
6X
6X
6X
6X
Publicidad
