Setting The Remote Control Ids; Setting Procedure - Panasonic GP-VD151 Instrucciones De Operación

Setting the remote control IDs

The wireless remote controller (optional accessory) is
capable of operating up to two units.
Set the remote control IDs for the units to enable the
operation of each unit when the [CAM1] or [CAM2] button of
the wireless remote controller is pressed.
p p When using a multiple number of units, set a different
remote control ID for each unit.
You cannot set the remote control IDs for this unit to
"CAM3" or "CAM4".
p p When using one unit, set the remote control ID to "CAM1"
unless the setting needs to be changed.

Setting procedure

Operate the IR ID switch on the units rear panel, and
select "CAM1" or "CAM2" as the remote control ID. (See
page 14)
The IR ID switch settings "CAM1" and "CAM2" correspond
to the [CAM1] and [CAM2] buttons on the wireless remote
controller.
(The factory setting is "CAM1".)
IR ID switches
[CAM1] and [CAM2] buttons
18 (E)