When Mounting The Unit On A Tripod - Panasonic GP-VD151 Instrucciones De Operación

Installation
 When mounting the unit on a tripod
p
Use a highly stable tripod which can bear the weight of the camera mounted on it.
Attach the tripod to the threaded hole for mounting the camera on the camera's bottom panel.
Place the tripod on a completely flat and level surface.
Tighten the screw by hand to mount the tripod securely.
Do not tighten the screw by rotating the camera body. Doing so may cause malfunctioning.
Use screw for mounting the tripod that satisfy the following standard.
Notes
p p Do not install the unit where people will be passing back and forth.
p p When using the unit mounted on a tripod, do not put the tripod high above the floor level.
p p Mount the unit securely so there is no looseness. Looseness may cause the unit to fall off and/or result in injuries.
p p When the unit is going to be used for a prolonged period of time, take steps to ensure that the unit will not topple or fall
over and that it will not fall off or fall down. After using the unit, restore the installation location to its original state without
delay.
Screw for mounting tripod (1/4-20UNC)
4.5 mm to 6 mm
{0.18 to 0.24 inches}
20 (E)