Special Cuts - Skil 3315 Instrucciones De Funcionamiento Y Seguridad

SM 2610012178 08-10:2610007743 07-09 3315 8/23/10 10:13 AM Page 56
Saw Operations
Cutting bowed material and round material are only examples
of special cuts.
Cutting Bowed Material
W RNING
fence (Figure 32). Always make certain that there is no gap
between the workpiece, fence and table along the line of cut .
Bent or warped workpieces can twist or rock and may cause
binding on the spinning saw blade while cutting.
Cutting Round or Irregularly Shaped Material
W RNING
a fixture designed to clamp the workpiece firmly against
the fence 7 and table. Rods have a tendency to roll while
being cut, causing the blade to "bite" and pull the work with
your hand into the blade (Figure 33).

Special Cuts

If workpiece is bowed or warped, clamp it
with the outside bowed face toward the
For round material 5 such as dowel
rods or tubing, always use a clamp 6 or
FIG. 32
Correct
FIG. 33
56
Incorrect