Installation; Mounting Applications; Portable Mounting Using Clamps - Skil 3315 Instrucciones De Funcionamiento Y Seguridad

SM 2610012178 08-10:2610007743 07-09 3315 8/23/10 10:13 AM Page 32

Installation

mounting Applications

Mount the saw to the workbench using the four mounting
holes (7/16 ) 1 to the workbench (Figure 11). Check for
"
clearance to the left and right of the saw.
1. Each of the four mounting holes 1 should be bolted
securely using 7/16" flat head screws, lock washers, and
hex nuts (not included).
2. Locate and mark where the saw is to be mounted.
3. Drill four (4) 7/16" diameter holes through workbench.
4. Place the compound miter saw on the workbench
aligning holes in base with holes drilled in workbench.
Install screws, lock washers and hex nuts.
Supporting surface where saw is to be mounted should be
examined carefully after mounting to insure that no movement
can occur during use. If any tipping or walking is noted, secure
the workbench or stand before operating the compound miter
saw.

Portable Mounting Using Clamps

• If necessary, clamp the compound miter saw to a
workbench or table top.
• Place two or more "C" clamps on the clamping areas and
secure (Figure 12).
NOTE: Always make sure you leave enough room in work
area to accommodate long workpieces.
Workbench
1
32
FIG. 11
1
1
1
FIG. 12