Saw Operations; Miter Cut - Skil 3315 Instrucciones De Funcionamiento Y Seguridad

SM 2610012178 08-10:2610007743 07-09 3315 8/23/10 10:13 AM Page 44

Saw Operations

• A miter cut is made at 0° bevel and any miter angle in the
range from 45° left to 45° right.
• The miter scale is cast-in on the base for easy reading.
• Positive detents have been provided for fast and accurate
mitering at 0°, 15°, 22.5°, and 45° left and right.
• There is also a crown molding detent at 31.6° (see
Cutting Crown Molding for more information, pages 50
and 53).
Follow these instructions for making your miter
cut:
1. Loosen miter lock knob 1. Press the miter detent trigger 2
and move the saw to the desired angle, using either the
detents 3 or the miter scale 4. Tighten miter lock knob
(Figure 28).
2. Properly position workpiece. Make sure workpiece is
clamped firmly against the table and the fence.
W RNING
on, lower head assembly to make sure clamp clears guard
and head assembly.
3. Activate the switch. Lower the head assembly and make
your cut.
4. Wait until blade comes to a complete stop before
returning head assembly to the raised position and/or
removing workpiece.

miter Cut

Use clamping position that does not
interfere with operation. Before switching
44
FIG. 28