Scope Of Delivery; Required Tools - Volkswagen Zubehör 5C0 064 317 N FKZ Instrucciones De Montaje

1
2

Scope of delivery

Item Designation
1 Trim foil for right section of bonnet
2 Trim foil for left section of bonnet
3 Trim foil for upper right section of tailgate
4 Trim foil for upper left section of tailgate
5 Trim foil for lower right section of tailgate
6 Trim foil for lower left section of tailgate
7 Trim foil for right section of roof
8 Trim foil for left section of roof
9 Assembly concentrate
10 Assembly aid
* Only for vehicles with no electric panorama sliding/
tilting glass roof
** For vehicles with an electric panorama sliding/tilting
glass roof (only 2 pieces)

Required tools

- Lint-free cloth
- Sponge
- Bucket
- Tape measure
- Spray bottle
- Squeegee
Distributed by Volkswagen Zubehör GmbH Printed in Germany by Volkswagen Zubehör GmbH 13.10.2011
3
4
7
8
Preparation - Cleaning adhesive
surfaces
Quantity
• The vehicle may not have been Nano sealed.
1
1
The trim foil will not adhere to Nano sealing treatments,
1
waxed surfaces or similar surface sealing treatments.
1
1
- Thoroughly wash assembly surfaces including edges,
swage lines, recesses, cracks etc. Do not use waxes or
1
similar additives.
1 *
- Dry assembly surfaces.
- Remove stickers, adhesive labels and adhesive
1 *
residues.
1
- Remove insect residues using insect
3 ** cleaner 00A.096.300.
- Remove remains of wax or similar sealing treatments
using activated foam cleaner 00A.096.301.
- Repair/remove paint damage, as necessary (observe
drying and curing periods).
- Thoroughly degrease assembly surfaces with a
cleaning cloth.
- Allow assembly surfaces to air dry for 5 minutes.
- To protect trim foil during assembly, wrap squeegee
with a soft lint-free cloth.
Positioning and applying foil
• Working temperature 15 - 30° C.
• No direct sunlight (the vehicle may not be heated by
the sun).
• Remove liner from trim foil only immediately before
installation.
• Ensure during the wet assembly process that the trim
foil does not dry out in areas still to be applied.
The foil can electrically charge during removal of the
♦
protective backing.
No fl uffy clothing should be worn during assembly
♦
procedures.
Open long hair should be tied back or wear a hat/hair
♦
net.
5
6
10
9
-19-