Maintenance schedule
After the work
ATTENTION
Risk of damage. Do not sluice the appli-
ance with water and do not use aggressive
detergents.
Drain off dirt water.
Remove the lid of the wastewater reser-
voir and wash the inside of the lid and
the float with water.
Rinse the dirt water tank with clear wa-
ter.
Clean the vacuum bar.
Remove bulk waste container and emp-
ty it.
Clean the outside of the appliance with
a damp cloth which has been soaked in
mild detergent.
Clean the vacuum lips, check for wear
and replace them if required.
Clean brush.
Check the brush for wear and replace if
required (see "Maintenance tasks").
Charge battery if required.
Weekly
Remove the water distribution bar on
the cleaning head and clean the water
channel.
1 Fresh water filter
Clean the fresh water filter.
Monthly
Check the condition of the seals be-
tween dirt water reservoir and cover, re-
place if required.
Yearly
Have the prescribed inspection carried
out by the customer service.
Maintenance Works
Replacing the suction lips
Compress the fastening devices and
pull the vacuum lips out of the vacuum
bar towards the bottom.
Remove the vacuum lips from the hold-
er.
Note:
Thanks to the perforation pattern the vacu-
um lips cannot be mixed up. They cannot
be turned and reinstalled.
Replace vacuum lips.
Insert the holder with the vacuum lips
into the vacuum bar and snap into
place.
Replacing the brush roller
WARNING
Risk of crushing due to the parking stand
folding up during the brush replacement.
Turn the steering wheel by 90° to the left
prior to the brush replacement.
Press the release button for the brush
roller and swivel the brush roller toward
the bottom and pull it off the driver.
Place the new brush roller on the driver
and lock into place on the opposite side.
Maintenance contract
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
– 7
EN
9