Programming The Robot - ECOVACS DEEBOT D77 Manual De Instrucciones

Edge Cleaning Mode: This mode is good for cleaning the edges of a room.
Spot Cleaning Mode: This mode is applicable for an area of highly concentrated dirt or dust.

3.4 Programming the Robot

DEEBOT can be programmed to automatically clean once per day, at a specific time, even if nobody is at home.
1. With the power ON, press and hold
setting flashes.
2. Enter the time you would like the robot to clean. Press
hour, and "minute" number will blink. Use the same method to adjust "minute" and press
Scheduled cleaning time is complete.
Example: If you would like the scheduled cleaning time to be set for 12:08 p.m.,
the display screen should read:
1. After scheduling the cleaning time, the
confirm the current time of day.
2. To set the current time of day, adjust the hours and minutes using the same method as schedule the cleaning
time above, or confirm the current time by pressing the (insert picture) key twice.
Set Cleaning Frequency / Cancel Scheduled Cleaning Time
1. Set the cleaning frequency by pressing the clock key
Clean once at scheduled time.
Clean daily at scheduled time.
Cancel cleaning at scheduled time. Robot only operates manually with this setting.
In Edge Cleaning Mode, the DEEBOT will detect a border - such as a wall - and it
will continue along that path until it meets an obstacle at which point it will alter
its direction.
In the Spot Cleaning Mode the robot operates in a "zigzag" pattern from left to
right, focusing on a specific area to clean. After the cleaning, the robot will return
to its starting point and emit a beep.
Schedule the Cleaning Time
until the symbol on the LCD illuminates and the number with time
Set / Confirm the Current Time of Day
icon disappears and the "hour" number blinks, indicating you can set or
EN
or key to adjust the "hour," press
until the desired icon appears.
to confirm the
to confirm.