Power On/Pause Mode/Power Off; Mode Selection - ECOVACS DEEBOT D77 Manual De Instrucciones

3.2 Power ON/Pause Mode/Power OFF

1. Turn ON the power switch
1. Pause the robot by pressing
any key on the display,
pressing the pause key on the
Remote Control, or by lifting
the unit off of the floor.

3.3 Mode Selection

The robot has several Cleaning Modes for you to choose from to effectively clean all of your floors.
Automatic Cleaning Mode: This is the most commonly used mode with the largest cleaning coverage.
In Automatic Cleaning Mode the robot will proceed in a straight line until it comes in contact with an obstacle
and then it will change course in a straight line.
If the DEEBOT detects a lot of dust during its initial route, it will change its path to fan-shaped or spiral route.
Intensive Cleaning Mode: This mode is good for aggressive cleaning, or for extremely dirty or dusty floors.
EN
on the bottom of the robot.
After pausing work, turn off the power switch at the bottom of the robot.
Note：When the robot is not working, it's suggested to keep it charging instead
of power OFF.
1.6 feet
When the robot works in Intensive Cleaning Mode, it follows the same pattern as
the Automatic Cleaning Mode but performs a more thorough cleaning.
In Intensive Cleaning Mode, the dust sensors sensitivity is increased, so cleaning
is more efficient.
2. Choose a cleaning mode by
pressing the Mode key on
the robot's control panel or
on the Remote Control.
Press Start/Pause key
start the robot.
2. Press Start/Pause key and
the robot will resume work.
When cleaning a small area like corners or a hallway
in Intensive Cleaning or Automatic Cleaning Mode
cleaning, the robot will automatically conduct a
"zigzag" pattern, then will return to the previous
mode to continue cleaning.
to