Design And Function; Transport, Packaging And Storage - Festo SPAW Manual De Instrucciones

3. ... / 4. Design and function / 5. Transport, packaging and storage
Specifications
Electrical connections
EN
Electrical safety
Operating medium
Materials, wetted parts
Materials, non-wetted parts
Approvals
CE conformity

4. Design and function

4.1 Description
By means of a sensor element and by supplying power, the prevailing pressure is converted into a switching signal or
an amplified standardised electrical signal via the deformation of a diaphragm. This electrical signal varies in proportion
to the pressure and can be evaluated accordingly.

5. Transport, packaging and storage

5.1 Transport
Check the instrument for any damage that may have been caused by transport.
Obvious damage must be reported immediately.
10
SPAW
Circular connector M12 x 1, 4-pin
Circular connector M12 x 1, 5-pin, only for version with two switching outputs and analogue
signal
Short-circuit resistance exists for analog- and switching outputs
Reverse polarity protection: U
Insulation voltage: DC 500 V
Overvoltage protection: DC 40 V
Compressed air per ISO 8573-1:2010 [-:-:-]
Gaseous media
Liquid media
(observe the media resistance of the wetted parts)
Process connection: Stainless steel 316L
Pressure sensor < 10 bar: Stainless steel 316L
Pressure sensor ≥ 10 bar: Stainless steel 13-8 PH
Case: Stainless steel 304
Keyboard TPE-E
Display window: PC
Display head: PC+ABS-Blend
cULus, RCM Mark
per EU EMC directive
vs. 0V
B
Pressure sensor SPAW