Operating Modes; Keys And Functions - Festo SPAW Manual De Instrucciones

6. Commissioning, operation

6.4 Operating modes

System start
Display is fully activated for 2 sec.
■
When the pressure sensor is powered up within the range of the hysteresis, the output switch is set to "not active" by
■
default.
Display mode
Normal operation, display pressure value
Programming mode
Setting the parameters

6.5 Keys and functions

The pressure sensor has two operating modes, the display mode and the programming mode. The selected operating
mode determines the respective function of the key.
Pressure sensor SPAW
Jumping into the programming mode
Keep the "MENU" key pressed for approx. 5 seconds. If the password is set to ≠ 0000, a
password will be requested. If authentication is successful, then it enters the programming
mode, otherwise it reverts to display mode.
Returning to the display mode
Simultaneous pressing of both keys.
EN
13