Specifications - Festo SPAW Manual De Instrucciones

2. Safety / 3. Specifications

3. Specifications

Specifications
EN
Model designation
Start of measuring range
End of measuring range
Overpressure safety
Display
Output signal
Zero offset adjustment
Analogue signal
Switching output
Power supply U
B
Current consumption
Total current consumption
8
SPAW
SPAW-... B2R B11R
bar -1 -1
bar 1 10
bar 2 20
14-segment LED, red, 4-digit, 9 mm character size
Display can be turned electronically through 180°
Update (adjustable): 100 / 200 / 500 / 1,000 ms
without analogue signal
■
4 ... 20 mA
■
DC 0 ... 10 V
■
2 x Switching output PNP (option: NPN)
max. 3 % FS
current output load: ≤ 500 Ω
voltage output load: > 10 kΩ
settling time: 3 ms
Switch point 1 and 2 are individually adjustable
Normally-open and normally-closed function: freely adjustable
Window and hysteresis function: freely adjustable
Switching current: maximum 250 mA
Switching voltage: Power supply - 1 V
Settling time: ≤ 10 ms
DC 15 ... 35 V
The power supply for the pressure sensor must be made via an energy-limited electrical circuit in
accordance with UL/EN/IEC 61010-1, or an LPS to UL/EN/IEC 60950-1, or class 2 in accordance with
UL1310/UL1585 (NEC or CEC). The power supply must be suitable for operation above 2,000 m should
the pressure sensor be used at this altitude.
Only ever use a power source that ensures a safe electrical isolation of the operating voltage in accord-
ance with IEC/DIN EN 60204-1. In addition, observe the general requirements for PELV circuits in
accordance with IEC/DIN EN 60204-1. Switching power supply units are permissible, if they ensure a
safe isolation as defined by IEC/EN 60950-1.
max. 100 mA
max. 600 mA including switching current
P2R P6R P10R
0 0 0
2 6 10
4 12 20
P16R P25R P50R
0 0 0
16 25 50
32 50 100
Pressure sensor SPAW
P100R
0
100
200