Tape Operations; Listening To A Cassette - JVC 3040641 Manual De Instrucciones

TAPE OPERATIONS

Listening to a cassette

You can play back type I (normal) tapes.
1
Open the control panel.
Note on One-Touch Operation:
When a cassette is already in the cassette
compartment, select tape as the source by
pressing TAPE CD-CH to start tape play
automatically.
2
Insert a cassette into the cassette
compartment.
3
Close the control panel by hand.
4
Select the tape direction.
10
The unit turns on and
tape play starts
automatically.
Tape–in indicator appears.
Each time you press `,
the tape direction changes
alternately forward
(TAPE ) and reverse
(TAPE ).
To stop play and eject the cassette
Press 0.
Tape play stops, the control panel opens and then
the cassette automatically ejects from the cassette
compartment. The source changes to the previously
selected one.
If you change the source, tape play also stops
(without ejecting the cassette this time).
• You can eject the cassette while the unit is turned
off by pressing 0.
To fast-forward and rewind a tape
Press ¢
1 second to fast-forward the
tape.
When the tape reaches its
end, the tape is reversed and
playback starts from the
beginning of the other side.
Press 4
1 second to rewind the tape.
When the tape reaches its
end, playback of the same
side starts.
To stop fast forward and rewind at any
position on the tape, press `.
Tape play starts from that position on the tape.
Notes:
• When one side of the tape reaches its end during
play, the other side of the tape automatically starts
playing. (Auto Reverse)
• When the tape reaches its end while fast-forwarding,
the tape direction will be changed automatically.
for more than
for more than