Other Convenient Tape Functions; Playing The Current Tune Repeatedly; Skipping The Blank Portions On The Tape - JVC 3040641 Manual De Instrucciones

Other convenient tape functions

Skipping the blank portions on the tape

You can skip blank portions between the tunes
(Blank Skip).
When this function is on, the unit skips blank
portions of 15 seconds or more, fast-forwards to
the next tune, then starts playing it.
• See also "Changing the general settings (PSM)"
on pages 15 and 16.
1
Press and hold SEL (select) for more
than 2 seconds so that one of the
PSM items appears on the display.
(PSM: see page 16.)
2
Press ¢
"B. SKIP (blank skip)."
3
Turn the control dial clockwise to
select "ON."
4
Finish the setting.
To cancel Blank Skip, repeat the same
procedure and select "OFF" in step 3 by turning
the control dial counterclockwise.
12
or 4
to select
Now Blank Skip is
activated.

Playing the current tune repeatedly

You can play the current tune repeatedly (Repeat
Play).
1
Press MODE to enter the functions
mode while playing a tune you
want to hear over again on a
cassette. "MODE" flashes on the
upper part of the display, and the
number buttons work as different
function buttons.
2
Press RPT (repeat), while "MODE"
is still on the display, so that the
RPT indicator lights up on the
display.
Lights up when Repeat Play is turned on.
When the tune has been played, the tape is
automatically rewound to the beginning of that
tune and the same tune will be played again.
To cancel Repeat Play, repeat steps 1 and 2
above again so that the RPT indicator goes off.
Note:
In the following cases, Blank Skip and Repeat Play
may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions during
tunes.
– Tapes with short non-recorded sections.
– Tapes with high level noise or humming between
tunes.
– Tapes with tunes recorded at low recording levels.
– The Dolby NR setting does not match. For example,
if Dolby B NR is on and the tape was recorded with
no Dolby NR.