Adjusting The Sound - JVC 3040641 Manual De Instrucciones

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
Each time you press the
button, the adjustable items
change as follows:
BAS
(bass)
VOL
(volume)
Indication To do:
1
BAS* Adjust the bass.
TRE* 1 Adjust the treble.
FAD* 2 Adjust the front
and rear speaker
balance.
BAL Adjust the left
and right speaker
balance.
1
*
LOUD Boost low and high
frequencies to
produce a well-
balanced sound
at low volume
level.
3
VOL* Adjust the volume. 00 (min.)
1
* When you adjust the bass, treble, or loudness, the
adjustment you have made is stored for the
currently selected sound mode (C-EQ) including
"USER."
2
* If you are using a two-speaker system, set the fader
level to "00."
3
* Normally the control dial works as the volume
control. So you do not have to select "VOL" to
adjust the volume level.
14
TRE FAD
(treble) (fader)
BAL
LOUD
(balance)
(loudness)
Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
|
50 (max.)
2
Adjust the level.
To increase the level or
turn on the loudness.
To decrease the level or
turn off the loudness.
Equalization pattern changes as
you adjust the bass or treble.
Ex. 1: When you adjust "TRE" (treble)
Ex. 2: When you turn on the loudness
3
Repeat steps 1 and 2 to adjust the
other items.
To reset each sound mode to the factory
settings, repeat the same procedure and
reassign the preset values listed in the table on
page 13.