Before Installation; Installation Procedure - Toto CST775 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Read these instructions thoroughly before beginning work.
Please leave instructions for customers. These instruction contain maintenance
and warranty information.
If necessary, remove the existing toilet.
IMPORTANT!
Due to the powerful performance of our Tornado, G-Max, E-Max and Power Gravity
flushing systems, they are not specified for back-to-back installations. The only
means of installing these toilets in a back-to-back situation is when the toilet drain
connections incorporate a WYE fitting. Please contact your builder or contractor prior
to this installation.
For your new TOTO toilet to fit correctly, the rough-in,
the distance between the finished wall to the center of
the closet flange, must be at least 12 inches for most
models.
NOTE: Models with 10" rough-in have model numbers
ending with ".10", for example C776CEFG.10.
1) Clean any debris out of the closet flange and then install
new mounting bolts (not supplied) into the slots of the
closet flange (see ill. 1). The head of the bolt should be
inserted into the slot with its threads facing upward.
2) Carefully turn the toilet upside down onto some padding.
Firmly press a new bowl wax ring (not supplied) onto the
circular recess around the toilet bowl's horn (see ill. 2). Turn
the toilet upright and gently lower into position over
the closet flange. With toilet properly aligned, press firmly
on both sides of toilet rim to set the bowl wax ring (see
ill. 3).
CAUTION: Do not move the bowl after the
bowl wax ring is set. Thread the nuts and
tighten evenly until bowl is snug to closet
flange. Install the bolt caps (see ill 3).
CAUTION: Do not overtighten the nuts as
damage to the china bowl may result.
NOTE: Rocking may occur depending on the
condition of the ooring. In that case, use
shims to prevent the toilet from rocking.

BEFORE INSTALLATION

Double Combination WYE / 1/8 Bend
YES

INSTALLATION PROCEDURE

Double Sanitary Tee / Sanitary Cross
Centerline of
Flange
ill. 3
Bolt Cap
Nut *
Washer *
Base Cap
Bowl Base
* Not Supplied
3
NO
Centerline of
Stop valve
8"
(203mm)
"RI"
ill. 1
ill. 2
Wax Ring
Horn
Three Points of Contact

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Cst776Cst785Cst786

Tabla de contenido