Connecting a dust extraction unit
♦
Attach the adapter for dust extraction
chip ejector
.
Optional depending on the diameter of the dust
and sawdust extraction.
♦
Connect an approved dust and chip extraction
device.
NOTE
►
When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance.
Use
Switching on and off
Switching on:
♦
Push the safety lock-out
and keep it pressed.
♦
Press the ON/OFF switch
light
lights up. Once the saw is running, you
can release the safety lock-out
Switching off:
♦
Release the ON/OFF switch
Battery charge level
♦
The status will be shown on the battery display
LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Overload warning
♦
If the appliance is in danger of overloading,
the overload warning
appliance switches off.
Setting the cutting angle
You can select the cutting angle using the cutting
angle scale
.
■
Undo the wing screw
preselector. Set the desired angle on the cutting
angle scale
using the top edge of the raised
black metal part (see fig. C). Retighten the wing
screw
.
│
GB │ IE
■
26
to the
to the left or right
. The LED work
.
.
lights up briefly. The
of the cutting angle
Fig. C: Setting the cutting angle to 45 degrees
Setting the cutting depth
NOTE
►
Select a cutting depth of approx. 3 mm more
than the thickness of the material. This ensures
that you achieve a clean cut.
♦
Undo the locking screw
cutting depth on the cutting depth scale
using the reference marks (see arrow in fig. D).
Retighten the locking screw
Fig. D: Setting the cutting depth
Working with the circular saw
1. Switch on the appliance – as described in
"Switching on and off" – and then place it
with the front edge of the base plate
material.
2. Align the machine using the rip fence
using a marked line.
0
and set the desired
.
on the
or by
PHKSA 12 A1