Checking Blade Guard Functionality; Operation; Fitting/Changing The Saw Blade; Rip Fence - Parkside PHKSA 12 A1 Traducción Del Manual De Instrucciones Original

1. To remove the battery pack
button and pull the battery pack
appliance.
2. Insert the battery pack
charger .
3. Insert the mains plug into the socket. The control
LED lights up red.
4. The green charge status indicator LED
that the charging process is complete and the
battery pack is ready.
5. Insert the battery pack

Checking blade guard functionality

♦ Pull the release lever for the blade guard
far as it will go.
The blade guard should move without jamming.
When letting go of the release lever for the blade
guard , it should automatically jump back to its
original position.

Operation

Fitting/changing the saw blade

Always remove the battery pack before changing
the saw blade !
1. Set the cutting depth (using the locking screw
to the minimum position, 0 mm.
2. Swing the blade guard
release lever and put the appliance down.
3. Press the spindle lock button
es) and hold it in.
4. Undo the tensioning screw
5. Now, remove the tensioning screw
clamping flange
Fig. A: Changing the saw blade
PHKSA 12 A1
, press the release
out of the
into the high-speed
indicates
back into the appliance.
back using the
(until it engag-
using a hex key
and the
(see also fig. A).
6. Pull the blade guard
the release lever
in this position.
7. Remove the saw blade
appliance from below.
5. Fitting a saw blade
order.
6. Press the spindle lock button
and use the hex key
screw .
WARNING!
► The arrow on the saw blade
spond to the arrow showing the direction of
as
rotation
blade guard
■ Ensure that the saw blade
rotational speed of the tool.

Rip fence

♦ Undo the wing screw for the rip fence
place the rip fence
♦ Set the desired cut width
using the scale on the rip fence
out in the base plate
)
The right recess in the base plate is for a cutting
angle of 0°. The left recess in the base plate is
for a cutting angle of 45°.
.
Fig. B: Cutting width 2 cm
♦ Retighten the wing screw for the rip fence
all the way back using
and keep the blade guard
carefully out of the
is done in the reverse
(until it engages)
to tighten the clamping
must corre-
(running direction shown on the
).
is suitable for the
in the rip fence slot
and the cut
(see also fig. B).
GB │ IE
and
.
.
│
25 ■