Checks After Care And Maintenance Work - Hilti WSR 36-A Manual De Instrucciones

Storage
CAUTION
Inadvertent damage caused by defective battery. A leaking battery may damage the tool.
▶ Always remove the battery before storing the tool.
• Store the tool and battery in a place that is as cool and dry as possible.
• Never store batteries in bulk form (loose, unprotected).
• Never store batteries in direct sunlight, on heating units or behind a window pane.
• Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
• Check the tool and batteries for damage before use after long periods of storage.

6.3 Checks after care and maintenance work

▶ After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
7 Troubleshooting
▶ If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
7.1 The reciprocating saw is not operational.
Malfunction
The LEDs indicate nothing.
1 LED blinks.
7.2 The reciprocating saw is operational.
Trouble or fault
The tool does not achieve full
power.
The saw blade can't be re-
moved from the chuck.
22
Possible cause
The battery is not fully inserted.
The battery is empty.
The transport lock is engaged.
The battery is discharged.
The battery is too hot or too cold.
Possible cause
The control switch is not fully
pressed.
The battery is discharged.
Stroke rate set too low.
The locking sleeve is not turned as
far as it will go.
Action to be taken
▶ Push the battery in until it
engages with a double click.
▶ Charge the battery.
▶ Disengage the transport lock.
▶ Change the battery and charge
the empty battery.
▶ Bring the battery to the recom-
mended working temperature.
Action to be taken
▶ Press the control switch fully.
▶ Change the battery and charge
the empty battery.
▶ Set the stroke rate regulator to
the setting recommended for
the material to be cut.
▶ Turn the locking sleeve as far as
it will go and remove the saw
blade.