1.3
Symbols used
The activities marked with this symbol may only
be carried out by a qualified electrician.
This symbol indicates an important note.
The symbol indicates additional, useful informa-
tion.
f This symbol is used to point out a call for action.
This symbol indicates a listing.
Î This symbol is used to refer to another section in this
manual.
This symbol is used to refer to another document.
9
This symbol is used to point out a result.
2. For your safety
2.1
Target groups
Operator
As the operator, you are responsible for the device. You
are responsible for proper and safe use of the device.
This includes instructing persons who use the device.
As an operator without specialist electrical training, you
may only carry out activities that do not require a qualified
electrician.
Qualified electrician
As a qualified electrician you have a recog-
nised qualification in electrical engineering. On
account of this specialist knowledge, you are
authorised to carry out the required electrical
tasks described in this manual.
Requirements for qualified electricians:
Knowledge of general and special regulations pertain-
ing to safety and accident prevention.
Knowledge of electrical regulations.
Knowledge of national regulations.
Ability to identify risks and avoid potential hazards.
2.2 Intended use
The device is a charging station for use in the private
sphere in which access is limited, such as private property,
company car parks or depots.
The device is intended exclusively for the charging of
electric vehicles.
Charging in accordance with Mode 3, as stipulated in
IEC 61851-1 for vehicles with batteries that do not gen-
erate gas.
Plugs and sockets according to IEC 62196.
Vehicles with batteries that generate gas cannot be
charged.
The device is intended for permanent installation and for
indoor and outdoor use.
The device is exclusively for use as a single charging
point.
EN
3