Symbols Used; For Your Safety; Target Groups; Intended Use - Mennekes AMTRON Serie Manual De Instrucciones

1.3

Symbols used

Only a qualified electrician may carry out opera-
tions marked with this symbol.
This symbol indicates an important note.
The symbol indicates additional,
useful information.
f This symbol marks a prompt for action.
„ This symbol marks a listing.
Î This symbol is used to refer to another section in this
manual.

This symbol is used to refer to another document.
9
This symbol is used to point out a result.

2 For your safety

2.1

Target groups

Owner
As the owner / operator, you are responsible for the
device. You are responsible for proper and safe use of
the device. This includes instructing persons who use the
device.
As an owner / operator without electrical engineering trai-
ning, you are only allowed to execute simple activities that
do not require a qualified electrician.
Qualified electrician
As a qualified electrician, you have received
recognised training in electrical engineering.
Based on this knowledge, you are authorized
to carry out the electrical work requested in this
manual.
Requirements for qualified electricians:
„ Knowledge of general and special regulations pertai-
ning to safety and accident prevention.
„ Knowledge of electrical regulations.
„ Knowledge of national regulations.
„ Ability to identify risks and avoid possible hazards.

2.2 Intended use

The device is a charging station for use in the private and
semi-public sphere with limited access, such as private
property, company car parks or municipal depots.
The device is intended exclusively for the charging of
electric vehicles.
„ Charging in accordance with Mode 3, as stipulated in
IEC 61851-1 for vehicles with batteries that do not gene-
rate gas.
„ Plugs and sockets according to IEC 62196.
Vehicles with batteries that generate gas cannot be char-
ged.
The unit is intended for permanent installation and for
indoor and outdoor use.
EN
3