Kit Preparation - Metra 99-7367 Instrucciones De Instalación

1. Place the vent trim ring into the
radio housing trim panel and
mount the vents using the factory
screws removed in disassembly.
Mount the clock and hazard
switch into the radio housing trim
panel using screws removed in
disassembly. (Figure A)
Note: If no factory clock is present,
a storage pocket and (4) # 8 x 3/8"
Phillips screws are provided.
2. Mount the start/stop switch or
blank plate depending on your
application into the radio housing
trim panel.
Note: If no switch is present there
are (2) #8 X 3/8" Phillips screws
supplied to mount the blank plate.
3. Install the (8) panel clips removed
in disassembly onto the radio
housing trim panel .
Continue to kit assembly

Kit Preparation

(Figure A)
99-7367
4